User manual

10 Low-speed ATM configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
10-36 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
Number of received Segment AIS Cells : 0
Number of received RDI Cells : 0
Number of received End RDI Cells : 0
Number of received Segment RDI Cells : 0
Number of received CC cells : 0
Number of received Loopback cells : 0
Number of received My loopback cells : 0
Total number of sent OAM Cells : 0
Number of sent AIS Cells : 0
Number of sent End AIS Cells : 0
Number of sent Segment AIS Cells : 0
Number of sent RDI Cells : 0
Number of sent End RDI Cells : 0
Number of sent Segment RDI Cells : 0
Number of sent CC cells : 0
Number of sent Loopback cells : 0
Number of sent My loopback cells : 0
10.11 Maintaining ATM
This section covers the following topics:
z
Clearing the ATM interface statistics
z
Setting loopback to detect if the interface is normal
z
Debugging ATM
10.11.1 Clearing the ATM interface statistics
After you confirm the clearing of the ATM interface statistics, run the reset command in the
user view.
Action Command
Clear the ATM interface statistics reset atm interface [ atm interface-number ]
10.11.2 Setting loopback to detect if the interface is normal
Setting the loopback (running the loopback command) causes the interfaces of the router or
the links to not work normally. Confirm the action before you set the loopback to detect the
interface.
When the router is faulty, set the local loopback to detect if the interface works normally. To
set the local loopback function, run the following commands in the interface view.