User manual

Nortel Secure Router 8000 Series
Configuration -WAN Access 10 Low-speed ATM configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 10-21
Step 2 Run:
interface atm interface-number[.subinterface ]
The ATM interface or the sub-interface view appears.
Step 3 Run:
pvc { pvc-name vpi/vci | vpi/vci }
The command creates a PVC and the PVC view appears.
NOTE
z
In normal cases, the vci values 3 and 4 are reserved for special usage. Nortel recommends users to
not use these two values.
z
The values of vpi and vci cannot be 0 at the same time.
Step 4 Run:
encapsulation aal5-encap
The command configures the encapsulation type of the PVC as AAL5.
The AAL5 encapsulation type for PVC can be aal5snap, or aal5mux or
aal5muxunstandard.
By default, the encapsulation type is aal5snap.
Step 5 Run:
map bridge virtual-ethernet interface-number
The IPoEoA mapping is configured on the PVC.
----End
10.5.3 Checking the configuration
Run the following commands to check the previous configuration.
Action Command
Check the configuration and
status of the ATM interface.
display interface atm [ interface-number ]
[ .subinterface ] [ | { begin | exclude | include }
regular-expression ] [ interface-type ]
Check the relevant
information of the PVC.
display atm pvc-info [ interface interface-type
interface-number [ .subinterface ] [ pvc { pvc-name
[ vpi/vci ] | vpi/vci } ] ]
Check the related information
about the PVC mapping.
display atm map-info [ interface interface-type
interface-number [ .subinterface ] [ pvc { pvc-name
[ vpi/vci ] | vpi/vci } ] ]
Check the state and statistics
of a VE interface.
display interface virtual-ethernet [ interface-number ]
[ | { begin | exclude | include } regular-expression ]