User manual

10 Low-speed ATM configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
10-18 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
10.4 Configuring the IPoA application
10.4.1 Establishing the configuration task
Applicable environment
To enable the ATM to carry IP packets, you need to create PVC first.
You can configure the IPoA application mapping on the PVC to make AAL5 bear IP packets.
Pre-configured tasks
Before configuring IPoA applications, complete the following tasks:
z
Configuring physical attributes for the ATM interface
z
Configuring an IP address and mask for the ATM interface (or sub-interface)
Data preparation
To configure the IPoA applications, you need the following data.
No. Data
1 Number of the ATM interface (or sub-interface)
2 IP address and mask of the ATM interface (or sub-interface)
3 PVC name, ATM network VPI and VCI
4 AAL5 encapsulation type
5 IP address and mask of the peer mapped to PVC
6 Interval of sending InARP packets
Configuration procedures
No. Procedure
1 Configuring IPoA mapping on a PVC
2 Checking the configuration
10.4.2 Configuring IPoA mapping on a PVC
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.