User manual

Nortel Secure Router 8000 Series
Configuration -WAN Access 10 Low-speed ATM configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 10-17
Step 3 Run:
atm-class atm-class-name
The command applies the ATM-class.
----End
Applying the ATM-class to a PVC
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface atm interface-number[.subinterface ]
The ATM interface or the sub-interface view appears.
Step 3 Run:
pvc { pvc-name vpi/vci | vpi/vci }
The command creates a PVC and the PVC view appears.
Step 4 Run:
atm-class atm-class-name
The command applies the ATM-class.
The same parameters that you configure directly in PVC view have the highest precedence.
Those of the ATM-class applied on the PVC and applied on the ATM interface rank second
and third respectively.
----End
10.3.4 Checking the configuration
Run the following commands to check the previous configuration.
Action Command
Check the configuration and
status of the ATM interface or
sub-interface.
display interface atm [ interface-number
[.subinterface ] ] [ | { begin | exclude | include }
regular-expression ] [ interface-type ]
Check information about the
PVC.
display atm pvc-info [ interface interface-type
interface-number [ .subinterface ] [ pvc { pvc-name
[ vpi/vci ] | vpi/vci } ] ]
Check information about the
ATM-class.
display atm class [ atm-class-name ]