User manual

Nortel Secure Router 8000 Series
Configuration -WAN Access 10 Low-speed ATM configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 10-15
Usage of input bandwidth: 0.00%, Usage of output bandwidth: 0.00%
Input: 0 packets, 0 bytes
0 input errors, 0 CRC, 0 giants
0 pads, 0 aborts, 0 overflows
Output:0 packets, 0 bytes
0 output errors, 0 underflows, 0 overflows
10.3 Configuring ATM-classes
10.3.1 Establishing the configuration task
Applicable environment
When configuring the same parameters such as PVC MAP, service category, encapsulation
type and OAM for multiple ATM main interfaces or PVCs, use the ATM-Class to avoid
configuring them for ATM interfaces or PVCs one by one.
Preconfiguration tasks
Before configuring an ATM-Class, complete the following tasks:
z
Configuring physical attributes for the ATM interface
z
Configuring an IP address and mask for the ATM interface or sub-interface
z
Creating PVC
Data preparation
To configure an ATM-Class, you need the following data.
No. Data
1 Number of the ATM interface or sub-interface
2 IP address and mask of ATM interface or sub-interface
3 PVC name and network VPI and VCI
4 ATM-Class name
5 MAP, service type, and encapsulation type and the related OAM parameters
Configuration procedures
No. Procedure
1 Creating an ATM-class
2 Applying the ATM-class
3 Checking the configuration