User manual

1 WAN access overview
Nortel Secure Router 8000 Series
Configuration -WAN Access
1-8 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
z
The network protocol address supported by the interface
z
The static route or dynamic routing protocol on the interface
z
The dial mapping, DDC operating parameters, and Modem management need to be
configured if the interface supports dial
z
Parameters about packet filtering and NAT if a firewall is set up on the interface
The SR8000 supports the description interface-description command, which configures descriptions
about an interface. The description about an interface helps identify interface function and maintain
interfaces.
1.2.4 Configuring interval of flow statistics
Configuring global interval of flow statistics
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface traffic sampling-time time global
The command sets the global interval of flow statistics.
You can apply the global interval of flow statistics set to various physical interfaces (not
including the controller interface) and the high-speed MP-Group interface.
----End
Configuring interface interval of flow statistics
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface interface-type interface-number
A specified interface view appears.
Step 3 Run:
interface traffic sampling-time time
The command sets the interface interval of flow statistics.
----End