User manual

1 WAN access overview
Nortel Secure Router 8000 Series
Configuration -WAN Access
1-6 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
1.2 Configuring WAN interface parameters
1.2.1 Establishing the configuration task
Applicable environment
The section describes how to configure WAN interfaces. You must run all configurations
related to interfaces in the interface views.
Table 1-3 Interface numbering
Product Numbering
Slot:
Secure Router 8000: numbered from left to right and from the
top down of the front chassis.
z
SR8008: 0 to 8.
z
SR8004: 0 to 4.
z
SR8002: 0 to 2.
z
SR8012: 1 to 10.
Card number: numbered from 0.
If there is no gusset plate, the number is fixed 0.
Secure Router 8000
routers
Interface number: numbered from 0.
It is marked on each interface board.
Pre-configuration tasks
Before configuring an interface, install the WAN interface card correctly on the router.
Data preparation
To configure a WAN interface, you need the following data.
No. Data
1 The interface type and the interface number
2 Description about the interface
3 Interval of flow statistics (optional)
Configuration procedures
No. Procedure
1 Entering the WAN interface view