User manual

8 Frame relay configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
8-52 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
1. Configure the link protocol on each interface to FR.
interface.
twork segment.
the system view.
Data preparati
onf u need the following data:
The VC number of each network segment is shown in Figure 8-7.
Configuration pro
Step 1 Confi
al 1/0/0.
w
[RouterA] interface serial1/0/0
ink-protocol fr
address 196.1.1.1 255.255.255.0
Step 2
w
[RouterB] interface serial1/0/0
ink-protocol fr
interface-type dce
0
col fr
ce-type nni
0
1/0/0.
ace Serial2/0/0 dlci 300
it
Serial 2/0/0.
2. Configure the working mode of each
3. Configure the VC number of each ne
4. Enable the FR switching on Router B and Router C in
5. Configure the FR switching route.
on
To c igure the FR switching route, yo
z
z
The IP address of Router A is 196.1.1.1/24.
z
The IP address of Router D is 196.1.1.2/24.
cedure
gure Router A.
# Configure Seri
<RouterA> system-vie
[RouterA-Serial1/0/0] l
[RouterA-Serial1/0/0] ip
[RouterA-S
erial1/0/0] quit
Configure Router B.
# Configure Serial 1/0/0.
<RouterB> system-vie
[RouterB-Serial1/0/0] l
[RouterB-Serial1/0/0] fr
[RouterB-S
erial1/0/0] fr dlci 10
[RouterB-fr-dlci-Seria
l1/0/0-100] quit
[RouterB-Serial1/0/0]
quit
# Configure Serial 2/0/0 and NNI.
[RouterB] interface serial2/
[RouterB-Serial2/0/0] link-proto
0/0
[RouterB-Serial2/0/0] fr interfa
[RouterB-Serial2/0/0] fr dlci 30
[RouterB-fr-dlci-Seria
l2/0/0-300] quit
[RouterB-Serial2/0/0]
quit
# Configure the FR switching route on Serial
[RouterB] fr switching
[RouterB] interface Serial1/0/0
[RouterB-Serial1/0/0] fr dlci-switch 100 interf
[RouterB-Serial1/0/0] qu
# Configure the FR switching route on
[RouterB] interface Serial2/0/0