User manual
Nortel Secure Router 8000 Series
Configuration -WAN Access 8 Frame relay configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 8-19
ip address ip-address { mask | mask-length }
The command configures the IP address of the MFR interface.
Step 4 Run:
fr interface-type dce
The command configures the FR interface type as DCE.
NOTE
The fr interface-type dce command is valid only for MFR main interfaces.
Step 5 Run:
fr dlci dlci-number
The command configures the DLCI of the interface.
Step 6 Run:
quit
Return to the interface view.
Step 7 Choose one of the following steps to configure the address mapping as required.
NOTE
The fr inarp command is valid only for MFR main interfaces.
z
Run the fr map ip { ip-address [ mask ] | default } dlci-number [ broadcast [ ietf |
nonstandard ] ] command to add a static address mapping.
z
Run the fr inarp [ ip ] [ dlci-number ] command to enable the dynamic address
mapping.
----End
8.4.3 Bundling an interface to the MFR interface
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface interface-type interface-number
The interface view appears.
Step 3 Run:
link-protocol fr mfr interface-number
The command binds the interface to the specified MFR interface
----End