User manual
7 LAPB and X.25 configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
7-36 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
x25 switch svc x.121-address [ sub-dest destination-address ] [ sub-source
source-address ] xot ip-address1 [ ip-address2 ] … [ ip-address6 ] [ xot-option ]
The command configures an SVC XOT route.
You must configure the local X.25 route in the SVC mode.
----End
PVC
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface serial interface-number
The interface view appears.
Step 3 Run:
x25 xot pvc pvc-number1 ip-address interface serial interface-number pvc pvc-number2
[ xot-option ]
The command configures the PVC XOT route.
----End
7.6.5 Configuring optional keepalive and Xot-source attributes
SVC
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
x25 switch svc x.121-address [ sub-dest destination-address ] [ sub-source
source-address ] xot ip-address
&<1-6> [ [ timer seconds ] [ retry times ] [ source
serial interface-number ] ] *
The command configures SVC Keepalive and XOT-source attributes.
----End