User manual

Nortel Secure Router 8000 Series
Configuration -WAN Access 6 PPP and MP configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 6-39
NOTE
z
After changing the parameters configured in the VT or the MP-group view, you need to use the
shutdown command in all the bound sub-channels to disable the MP binding.
z
Then use the undo shutdown command in all the bound sub-channels to bind MP again.
z
Finally, all the configured commands will be effective.
6.9.2 Configuring the MTU of the MP group
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface mp-group number
The MP group interface appears.
Step 3 Run:
myu mtu
The command configures the MTU of the MP group.
Maximum Transmission Unit (MTU) is in bytes. The value ranges from 328 to 1500.
By default, MTU is 1500 bytes.
----End
6.9.3 Configuring the maximum number of MP bundled links
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Choose one of the following steps to enter the interface view as required.
z
Run the interface virtual-template number command to enter the VT view.
z
Run the interface mp-group number command to enter the MP-group interface view.
Step 3 Run:
ppp mp max-bind max-bind-number
The command configures the maximum number of MP bundled links.