User manual
Nortel Secure Router 8000 Series
Configuration -WAN Access 6 PPP and MP configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 6-35
Step 2 Run:
interface mp-group number
The command creates the MP-group interface.
NOTE
The SR8000 is an integrated device. The numbering of MP-group interfaces follows certain limitations.
The slot number and card number are fixed as 0.
Step 3 Run:
ip address ip-address { mask | mask-length } [ sub ]
The IP address is assigned for the MP-group interface.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
interface interface-type interface-number
The interface view appears.
Step 6 Run:
ppp mp mp-group number
The command adds the interface into the MP-group.
----End
Adding the interface of high-speed card to the MP-group
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface mp-group number
The command creates the MP-group interface.
NOTE
The SR8000 is an integrated device. The numbering of MP-group interfaces follows certain limitations.
The slot number and card number are fixed as 0.
Step 3 Run:
hic-bind enable
Specify the MP-group interface as the high-speed MP-group interface.
Step 4 Run: