User manual
Nortel Secure Router 8000 Series
Configuration -WAN Access 6 PPP and MP configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 6-27
No. Data
1 Interface number of the router
2 Number of the VT
3 IP address and subnet mask of the VT
Configuration procedures
No. Procedure
1 Creating a VT and assigning an IP address
2 Directly binding the interface to an existing VT
3 Checking the configuration
NOTE
You need to configure the local and the peer ends separately. The methods are the same.
6.6.2 Creating a VT and assigning an IP address
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface virtual-template number
A VT is created.
Step 3 Run:
ip address ip-address { mask | mask-length } [ sub ]
The command assigns an IP address to the VT.
----End
6.6.3 Directly binding the interface to an existing VT
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run: