User manual

6 PPP and MP configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
6-10 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
This section describes how to configure PAP unidirectional authentication.
Preconfiguration tasks
Before configuring PAP authentication, complete the following tasks:
z
Configuring physical attributes of the router interfaces.
z
Encapsulating the interface with PPP.
Data preparation
To configure PAP, you need the following data.
No. Data
1 Interface number of the router
2 Username and password of the peer to be authenticated
Configuration procedures
No. Procedure
1 Configuring a local router to authenticate iIts peer in PAP mode
2 Configuring the peer to be authenticated by the local router in PAP mode
3 Checking the configuration
6.3.2 Configuring a local router to authenticate iIts peer in PAP
mode
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
aaa
The AAA view appears.
Step 3 Run:
local-user user-name password { simple | cipher } password
The command adds the user name and password of the authenticated into the local user list.
Step 4 Run:
quit