User manual

5 Logical interface configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
5-8 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes
0 errors, 0 drops, 0 unknown protocol
Output:0 packets, 0 bytes
0 errors, 0 drops
Run the display fr interface command to view information about the status and configuration
of the FR sub-interface.
<Nortel> display fr interface
Serial6/0/0, DTE, physical up, protocol up
Serial6/0/0.2, multi-point, protocol up
Run the display atm interface command to view the status and statistics information about
the ATM sub-interface.
<Nortel> display atm interface atm 6/0/0.2
ATM interface Atm6/0/0.2, multi-point, State UP
Sub-interface Information:
PVCs: 1, MAPs: 1
input pkts: 5, input bytes: 460, input pkt errors: 5
output pkts: 5, output bytes: 460, output pkt errors: 5
5.3 Configuring the virtual template
z
The newly configured or modified parameters of a virtual template can take effect only
after you run the shutdown and the undo shutdown command.
z
To configure or modify services such as MPLS, MTU or ISIS, configure or modify those
services, and then perform related VT configuration on the other interfaces.
5.3.1 Establishing the configuration task
Applicable environment
You use the virtual template (VT) in VPN, MP and ATM applications. The system creates and
deletes virtual access interfaces and the process is transparent to users.
The link layer of VTs supports only the PPP protocol and the network layer supports only IP.
Preconfiguration tasks
Before configuring a virtual template, complete the following tasks:
z
Installing and powering on the router properly
z
Configuring the physical interface