User manual

Installing and Maintaining the Versalar Switch Router 15000
2-22
308684-B Rev 00
3.
Ensure that the slots in the Versalar 15000 flanges align with the holes in
the rack.
If the holes in the rack’s vertical supports are not threaded for cagenut screws,
insert a cagenut in 8 locations. (See Figure 2-9
.)
4.
Mount the vertical flanges on the Versalar 15000 as shown in Figure 2-9.
5.
Holding the Versalar 15000 in position, align the flanges with two holes
on each side of the vertical rack support (Figure 2-10)
.
It is easiest to complete this step with two people. Make sure that the hole
pairs on either side of the vertical support match horizontally.
6.
Insert a cagenut screw through each flange hole and into the
corresponding hole in the rack.
7.
Tighten each cagenut screw with a Phillips screwdriver.