User manual

Installing and Maintaining the Versalar Switch Router 15000
2-16
308684-B Rev 00
Mounting the Versalar 15000 in an Optional 23-Inch Rack
To install the Versalar 15000 in a 23-inch four-post rack:
1.
Measure at least 27 in. (68.6 cm) of free vertical space inside the rack and
mark the spot.
2.
Mount the angle brackets supplied with the 23-inch rack mount kit
horizontally in the area indicated in Figure 2-6
.
3.
Using a Phillips screwdriver, remove the 5 screws securing each of the two
vertical flanges to the Versalar 15000 (Figure 2-7)
. Discard the flanges.
4.
Using the 8 screws that you removed from the vertical flanges, install the
flanges supplied with the 23-inch rack mount kit as shown in Figure 2-7.
5.
If the holes in the rack’s vertical supports are not threaded for cagenut
screws, insert a cagenut in five locations.
6.
Holding the Versalar 15000 in position, align the flanges with two holes
on each side of the vertical rack support (Figure 2-8)
.
It is easiest to complete this step with two people. Make sure that the hole
pairs on either side of the vertical support match horizontally.
7.
Insert a cagenut screw through each flange hole and into the
corresponding hole in the rack.
8.
Tighten each cagenut screw with a Phillips screwdriver.
Note:
The angle brackets supplied with the 23-inch rack mount kit are wider
than the angle brackets supplied with the chassis.