User manual

Versalar 15000 Hardware Description
308684-B Rev 00
1-23
Table 1-9 describes the Packet TP card LEDs.
Table 1-9. Packet TP Card LEDs
LED State Meaning
Pwr Off Power is off.
On (green) Power is on.
Stat Off The LED is not functioning.
On (green) The TP card is operating normally.
Flashing (green) Power-up diagnostic testing is in progress.
Diagnostic testing occurs when you cold-start
the module by cycling power, issuing the
diags
command from the BCC, or installing the TP
card with the power on.
On (amber) Power-up diagnostic testing failed. The TP card
is waiting for an automatic attempt to reinitiate
diagnostic testing. If the Stat LED lights amber
again, call the Nortel Networks Technical
Solutions Center.
Run Off The processor code is not loaded.
On (green) The boot process is complete.
Flashing (green) The router is booting.
On (amber) A fault is detected. Call the Nortel Networks
Technical Solutions Center.
Phy Off The trunk interface card is not installed.
On (green) The trunk interface card is present.
POS Off POS interface is not configured. (RFU)
On (green) POS interface is configured. (RFU)
Enet Off Enet interface is not configured.
On (green) Enet interface is configured.
Pri IFP Off The primary IFP card is not in use.
On (green) The primary IFP card is in use.
Sec IFP Off The secondary IFP card is not in use.
On (green) The secondary IFP card is in use.
Link (port
n
) Off Link is not detected on the port.
On (green) Link is achieved on the port.
(continued)