User manual

Installing and Maintaining the Versalar Switch Router 15000
1-20
308684-B Rev 00
Table 1-8 describes the ATM OC-12c/STM TP card LEDs.
Table 1-8.
ATM OC-12c/STM TP
Card LEDs
LED State Meaning
Pwr Off Power is off.
On (green) Power is on.
Stat Off LED is not functioning.
On (green) TP card is operating normally.
Flashing (green) Power-up diagnostic testing is in progress.
Diagnostic testing occurs when you cold-start the
module by cycling power, issuing the
diags
command from the BCC, or installing the TP card
with the power on.
On (amber) Power-up diagnostic testing failed. The TP card is
waiting for an automatic attempt to reinitiate
diagnostic testing. If the Stat LED lights amber
again, call the Nortel Networks Technical Solutions
Center.
Run Off Processor code is not loaded.
On (green) Boot process is complete.
Flashing (green) Booting.
On (amber) A fault is detected. Call the Nortel Networks
Technical Solutions Center.
Phy Off Trunk interface card is not installed.
On (green) Trunk interface card is present.
Sar Off Not loaded.
Flashing (green) Booting.
On (green) Boot is complete.
Pri IFP Off Primary IFP card is not in use.
On (green) Primary IFP card is in use.
Sec IFP Off Secondary IFP card is not in use.
On (green) Secondary IFP card is in use.
Link (port
n
) Off Frame synchronization is not detected on the port.
On (green) Frame synchronization is achieved on the port.
(continued)