User manual

Versalar 15000 Hardware Description
308684-B Rev 00
1-9
AP Card LEDs
Table 1-3
describes the LEDs for all AP cards. This group of LEDs is the same for
all the AP cards.
Table 1-3. AP Card LEDs
LED State Meaning
Pwr Off CAP card is turned off.
On (green) CAP card is turned on.
Stat Off LED is not functioning.
On (green) CAP card is operating normally.
Flashing (green) Power-up diagnostic testing is in progress. Diagnostic
testing occurs when you cold-start the module by cycling
power, issuing the
diags
command from the Bay
Command Console (BCC
™
), or installing the CAP card
with the power on.
On (amber) Diagnostic testing failed. The CAP card is waiting for an
automatic attempt to reinitiate diagnostic testing. If the
Stat LED lights amber again, call the Nortel Networks
Technical Solutions Center.
Run Off The processor code is not loaded.
On (green) The processor code loaded successfully.
Flashing (green) The processor code is loading.
On (amber) A failure was detected.
Phy Off No interface card is installed in the interface card slot
corresponding to this CAP card.
On (green) A T3 or ARM interface card is present in the interface
card slot corresponding to this CAP card.
N+1 Off N+1 failover operation is not engaged.
On (green) N+1 failover operation is engaged; that is:
• CAP card is present in processor card slot 5.
• ARM card is present in interface card slot 5.
• N+1 failover condition occurred.
• CAP card present in processor card slot 5 assumes
the function of the failing CAP card.
Slots1 to 4 Off N+1 failover operation is not engaged for this slot.
On (green) Indicates which CAP card failed. The N+1 CAP card is
servicing the CAP card installed in this slot.