User manual

Installing and Maintaining the Versalar Switch Router 15000
5-10
308684-B Rev 00
Protecting Memory Card Files
Nortel Networks ships each memory card with its read-write protect switch in the
unprotected position. After successfully loading the configuration file and saving
your configuration, you might want to write-protect the memory card for backup
purposes.
To change memory card protection:
1.
Remove the memory card access cover by squeezing the sides of the cover
at the top and bottom (Figure 5-4 on page 5-7
).
2.
Remove the memory card from the Versalar 15000:
a.
Press the eject button above the memory card receptacle (Figure 5-5
on page 5-8).
b.
Pull the card out of the card receptacle.
3.
Locate the read-write protect switch on the edge opposite the arrow on
the memory card (Figure 5-7)
.
Note:
You typically do not operate a Versalar 15000 with a write-protected
memory card. You should make a copy of your configuration on another
memory card, write-protect that card, and store it in a safe place.
Caution:
You must remove the card from the Versalar 15000 before changing
the read-write protection. Failure to remove the card may result in improper
write protection.