User manual

Installing and Maintaining the Versalar Switch Router 15000
5-2
308684-B Rev 00
Verifying a Successful Installation
After connecting the Versalar 15000 to the network, you can verify a successful
installation by checking the LEDs on the processor and interface cards.
When you turn on the Versalar 15000, the following sequence of processor and
interface card LEDs should occur:
1.
The power LEDs light green when the Versalar 15000 is turned on.
2.
As the diagnostic procedure tests each card, the status LED representing that
card slowly flashes green.
3.
After the diagnostic testing procedure completes, the boot process begins. The
run LEDs flash green while each card is booting.
4.
After the boot process completes, the run LEDs stay green, indicating that the
cards are operational.
If the LEDs on the cards light in this sequence, your installation is successful.
Contact your network administrator to verify that the Versalar 15000 is now
connected to the network.
If the LEDs do not light in this sequence, contact your local Nortel Networks
Technical Solutions Center.