User manual

308614-14.20 Rev 00
4-1
Chapter 4
Configuring Netboot Client Services
This chapter describes how to enable AN/ANH or ARN routers for netboot startup
options using commands at the Technician Interface or AN Monitor prompt.
First, read “Using Netboot Configuration Commands
” on page 4-2 for
information about working with someone at a remote AN/ANH or ARN router
site or accessing a router command line. Then, complete the appropriate sections
of this chapter for the AN/ANH or ARN router’s startup configuration:
Topic Page
Using Netboot Configuration Commands
4-2
Setting the Boot Configuration 4-3
Setting the Netboot Interface Configuration 4-5
Verifying Your Configuration 4-10
What to Do Next 4-11
For This Startup Configuration Complete These Sections
Netboot or Directed Netboot over a
serial interface
• Setting the Boot Configuration
• Configuring a Serial Interface for Network
Booting
Netboot or Directed Netboot over an
Ethernet interface
• Setting the Boot Configuration
• Configuring an Ethernet Interface for Network
Booting
Netboot or Directed Netboot of an
ARN over a token ring interface
• Setting the Boot Configuration
• Configuring an ARN Token Ring Interface for
Network Booting