User manual

Using the Quick-Start Local Boot Procedure
308614-14.20 Rev 00
C-15
8.
Using your completed Quick-Start worksheets, enter the appropriate
network information in response to the prompts.
The AN/ANH or ARN router uses this information to configure interfaces to
the network.
The script prompts you for information in this order:
• The initial Global Information worksheet information
• Specific protocol information
• Wide area protocol selection
• Specific protocol information
• The rest of the Global Information worksheet information
After you enter all of the Global Information worksheet and protocol
information, the script displays a configuration summary and prompts you to
save the configuration to a file.
9. Save the configuration file.
Table C-1. Quick-Start Commands
Task Action Details
Accept a default
value
Press [Return] Your console displays default values in
brackets; for example, [E11].
Repeat a step (for
example, if you make
a mistake)
Press [Control]-c;
then, type n
When you press [Control]-c, the script
prompts Terminate script y/n? Ty p e n
to return to the beginning of the step so that
you can reenter the information.
Stop the Quick-Start
procedure
Press [Control]-c;
then, type y
When you press [Control]-c, the script
prompts Terminate script y/n? Ty p e y
to terminate the procedure and return to the
Technician Interface prompt.
To restart the Quick-Start procedure, reboot
the router by entering boot.
Note:
If the AN/ANH or ARN router will use a routine startup procedure
other than Directed Netboot, be sure to name the configuration file config.