User manual

Troubleshooting Network Boot Problems
308614-14.20 Rev 00
B-11
The following sample response shows the default settings for an AN/ANH with
one Ethernet interface and two synchronous interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
XCVR1..None
COM1...EZ-Install
COM2...EZ-Install
The following sample response shows the settings for an ARN with one Ethernet
interface, one token ring interface, and five synchronous interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...EZ-Install
COM2...EZ-Install
COM3...EZ-Install
COM4...EZ-Install
COM5...EZ-Install
The possible settings for boot image and boot config are network
and
local. If
the setting is
network, the AN/ANH or ARN router requests the kernel file or
configuration file from a BootP server when booting. If the setting is
local, the
router uses the kernel file or configuration file stored in flash memory.
The
XCVR parameter shows the current setting of the Ethernet connectors. The COM
parameters show the current settings of the synchronous connectors. The MAU
parameter shows the setting of the token ring connectors (ARN only).