User's Manual

Chapter 6 Installing the BCM main unit 93
BCM200/400 4.0 Installation and Maintenance Guide
To attach the rack-mount brackets
1 Place the BCM main unit on a flat, clean surface.
2 Align the screw holes between the BCM main unit and the right rack-mount bracket.
3 Fasten the bracket to the BCM main unit using four screws.
4 Align the screw holes between the BCM main unit and the left rack-mount bracket.
5 Fasten the bracket to the main unit using four screws. Refer to Figure 51, Figure 52, or Figure
53.
Figure 51 Attach the rack-mount bracket to the BCM200 main unit
Caution: Use only the screws supplied with the rack-mount bracket. Do not replace
the screws. Other screws can damage the unit.
Note: Rack-mount bracket
The expansion unit rack-mount bracket has an additional set of holes that allows you
to install the brackets so that the expansion unit sits flush with the BCM main unit in
an equipment rack.
Install rack-mount
bracket screws