User's Manual
84 Chapter 4 Installation overview
N0060612N0060612
Table 23 BCM system installation overview (Sheet 1 of 2)
Tasks Description Link to
Prepare for installation Verify these requirements:
• environmental
• electrical
• site telephony wiring
“Checking the installation
prerequisites” on page 87
Get required equipment
and tools
Ensure you have these items:
• basic hardware
• optional equipment
• other hardware and tools
“System equipment,
supplies, and tools” on
page 89
Check required
prerequisites
Verify environmental, electrical, and general requirements. “Checking the installation
prerequisites” on page 87
Install the main unit Mount the main unit using these options:
• in an equipment rack with a rack-mount shelf
• on a wall with a wall-mount bracket
• on a desktop
“Installing the BCM main
unit” on page 91
Install an expansion unit
(optional)
Mount the expansion unit using the same options as the
main unit:
• in an equipment rack with a rack-mount shelf
• on a wall with a wall-mount bracket
• on a desktop
“Installing the expansion
unit” on page 102
Install a media bay
module (MBM)
Follow these steps to install an MBM:
• set the MBM DIP switches
• insert the MBM into the main unit or expansion unit
“Installing a media bay
module (MBM)” on page
105
Connect the cables Connect the cables between these items:
• power supply to units
• lines and extensions to the MBMs
• data networking hardware
“Connecting the cables”
on page 137
Install telephones and
peripherals
These telephones can be installed:
• System telephones
• Emergency telephone
• IP Phones
• T7406 cordless system
“Installing telephones and
peripherals” on page 161
Install an ATA2 Perform the steps to install an ATA2:
• connect the ATA2
• mount the ATA2
• test insertion loss measurement
• configure the ATA2
“Installing the analog
terminal adapter” on page
167
Install optional telephony
equipment
Perform the steps to install:
• auxiliary ringer
• external paging system
• external music source
“Installing optional
telephony equipment” on
page 173