User's Manual

298 Chapter 23 Replacing or upgrading a power supply

N0060612N0060612

• If you are installing the redundant power supply for the first time, remove both power

supply modules from the redundant power supply cage. Remove the power supply

modules before you install the power supply in the platform base chassis (see Figure 159).

Figure 159 Remove the power supply module from the power supply cage

5 Place the power supply module on a flat, clean, static-free surface.

6 Repeat this step for any remaining power supply modules.

Rear view:

Power supply modules slide out of the power

supply cage.

Unfasten the power supply

module locking nut

Lift the power supply

module handle

Compress the locking

tab toward the handle