User's Manual

Chapter 23 Replacing or upgrading a power supply 281

BCM200/400 4.0 Installation and Maintenance Guide

Figure 140 Install the BCM200 MSC guide bracket

7 Connect a P1 power cable to the media bay backplane connector. Tie-wrap the excess cable as

shown in Figure 141.

Figure 141 Tie-wrap excess P1 power cable length

8 Connect the hard disk cable to the secondary IDE I/O card connection. Connect the hard disk

cable to the hard disk connector. Connect the power connector to the hard disk (see Figure

141). Insert extra connectors under the hard disk.

9 Connect the 20-pin motherboard power cable (P1) and the +12v power cable (P9) to the I/O

card.

Fasten BCM200

MSC guide bracket

mounting screws

BCM200 MSC guide bracket

I/O Card

Hard disk

Fan

MSC

Media bay module backplane

I/O card

Power supply

P1 cable

tie-wrap