Manualshelf

User's Manual

ManualsBrandsNortel Networks ManualsNetwork HardwareNortel Networks Network Hardware 400 4.0
141142143144145146147148149150
Chapter 9 Connecting the cables 145
BCM200/400 4.0 Installation and Maintenance Guide
To connect the DSM16+, DSM32+, ASM8, GASM8, or 4x16 MBMs
1 Wire 16 wire pairs from the amphenol connector to the local connecting blocks so they
connect to the 16 station sets you want connected to this MBM.
Table 48 provides the wiring scheme for the DSM16+, 4x16, and DSM32+ MBMs. The sets
heading indicates the set numbering for each of the amphenol pairs. Set DNs are allocated by
the BCM system based on the DS30 bus setting on the station MBM.
Note: Use 16 wire pairs from each connector for the DSM 32.
Note: If you are connecting a DSM16+, 4x16, or DSM32+, use Table 48. If you are
connecting an ASM8 or GASM8, use Table 49.