User's Manual

120 Chapter 8 Installing a media bay module (MBM)
N0060612N0060612
Setting MBM DIP switches
Before you install the MBMs into the BCM system, you must set the DIP switches. Make a note of
these settings either on the chart shown in Table 28 or in the Programming Record form.
To set MBM DIP switches
1 Locate the DIP switches on the MBM. See Figure 70.
Figure 70 MBM DIP switches
2 Set the switches to correspond with the settings you chose in the procedure “To determine
MBM DIP switch settings” on page 116.
3 Repeat step 2 for each MBM you want to install.
Note: The GASM and GATM MBMs have a different DIP switch configuration
than shown in Figure 70.
654 3 21
Off
On
Underside of the
MBM
DIP switches
Back of the MBM
123456
On
Off
Rear view of the MBM
MBM is
right-side up