User's Manual
Table Of Contents
- Getting Started with the Business Policy Switch 2000 Management Software
- Contents
- Figures
- Tables
- Preface
- Chapter 1: Management basics
- Chapter 2: Installing Device Manager software
- Chapter 3: Device Manager basics
- Chapter 4: Web management interface basics
- Index

38 Chapter 3 Device Manager basics
209321-A
Selecting multiple objects
To select multiple objects of the same type (such as ports or switches of the same
type):
➨ Do one of the following:
• For a block of contiguous ports, drag to select the group of ports.
• For multiple ports, MDAs, or switches in the stack, [Ctrl]-click on the
objects.
To select all the ports in a standalone switch or in a switch stack:
➨ Choose Edit > Select > Ports.
To select all the “units” (switches and MDAs, but not ports):
➨ Choose Edit > Select > Units.
To select an entire stack:
➨ Choose Edit > Select > Chassis.
Viewing information about an MDA
To view information about an MDA:
1 Select the MDA.
2 Choose Edit > Unit.
The Edit > Unit dialog box opens for the MDA (Figure 9). The Edit > Unit
dialog box describes the MDA installed in the switch.
Note: In a switch stack that contains Business Policy Switches and
BayStack switches, you can select only one type of switch at a time.