IP Telephone User Guide LIP-6812 SIP (Session Initiation Protocol) Broadworks Please read this manual carefully before operating your set. Retain manual for future reference. LGN6812SB-1219-01.
LIP-6812 User Guide Regulatory & Safety Notice LIP-6812D This equipment complies with the following regulatory standards, FCC Part 15, IC (Industry Canada) CS03, TBR21, TBR03, and TBR04. Also, this equipment complies with the safety requirements of UL60950, CSA60950, EN60950, EN55022 and EN55024 FCC Compliance Statement This device complies with part 15 of the FCC Rules for a Class B device.
LIP-6812 User Guide Table of Contents 1. Introducing the LIP-6812......................................................................1 1.1. 1.2. 1.3. LIP-6812 Overview .............................................................................................1 LIP-6812 Features..............................................................................................1 LIP-6812 General Description ............................................................................2 2.
LIP-6812 User Guide 1. Introducing the LIP-6812 1.1. LIP-6812 Overview LIP-6812 is an Internet Protocol (IP) phone designed to support hosted telephony services over a managed IP network. Based on the open standard Session Initiation Protocol (SIP), LIP-6812 can interoperate with various third party SIP end-user devices, Proxy/Registrar/Servers, and gateway products while voice packets are exchanged on a point-to-point basis between the phone and the connected party through the Service Provider’s network.
LIP-6812 - User Guide Last Number Redial Call Return Station-to-Station dialing Handset, Headset, Speakerphone, and Ring Volume control LCD Contrast control Call Hold Ringback Hands-free dialing Label for Programmed feature buttons Full Duplex Speakerphone Multiple Ring types Distinctive Ring tones G.723.1A / G.
LIP-6812 User Guide Figure 2. LIP-6812 Buttons NUMBER 1 BUTTON FUNCTION Left direction button. When appears in the bottom-left corner of the LCD, the previous menu may be selected. Right direction button. When ¼ appears in the bottom-right corner of the LCD, the next group of Softkeys may be selected. 2 Softkeys. Softkeys are interactive, changing function based on the LIP Phone status. When selected and verified, by pressing the [ OK ] Softkey, the IP phone performs the selected function.
LIP-6812 8 User Guide Flexible buttons (11) with Red/Green LEDs. Assign as Line or Feature using LCD Menu or Web Manager. Default assignments for buttons 1 and 2 are primary and secondary Line appearance for the extension.
LIP-6812 User Guide 2. Using Basic LIP-6812 Features The LIP-6812 is equipped with Softkeys and two direction buttons, which are used to navigate and select items from the display menu. An item can be selected using the Softkeys when it is displayed on the LCD screen. The Softkeys are also employed to access any Advanced Services to which your company has subscribed. Some buttons on the LIP-6812 represent Lines or SIP call appearances.
LIP-6812 User Guide NOTE: Calls can not be received unless the Line is registered to a Call Server. When not registered, the Line button LED will blink red and orange. 2.2. Making a Call You can make a call using on-hook or off-hook dialing. To place a call: 1) Lift the handset, press , press , or press Line button. 2) Dial the destination phone number; you may need to dial ‘#’ at the end of the number. 3) When the called party answers, begin speaking (the LCD will display the elapsed call time).
LIP-6812 User Guide To cancel the Transfer: 1) Press the [Cncl] Softkey. 2.5. Transferring Calls, Blind/Unannounced You can transfer an active call to another extension without talking to the party who is to receive the call, using Blind Transfer. The caller is transferred to the new party without verifying that the new party is there or willing to receive the call. To transfer an active call: 1) Press [BXfr] Softkey. 2) Dial the number you wish to receive the transfer.
LIP-6812 User Guide 2.7. 3-Party Conference The LIP-6812 3-Party Conference feature lets you speak with two other parties at once. To initiate a conference between the current party, you, and another party: 1) Press the [Conf] Softkey, and dial the number you want to join in the conference. 2) When the party answers, press the [Join] Softkey to establish the conference. NOTE: If the new party does not answer, press the [EndC] Softkey to return to the original party.
LIP-6812 User Guide NOTE: Your IP phone will not recall the last call dialed number after a loss of system power. 2.10. Last Call Return You can dial the number associated with the last incoming call, allowing you to return a call to the caller. To call back the last incoming caller: 1) Press [LCR ] Softkey. 2.11.
LIP-6812 User Guide the DND button must be assigned (refer to the Installer Guide for the steps to configure the Flexible button). To activate DND: 1) Press the DND Flexible button; when activated, the button LED will illuminate red, and “Do not disturb” is displayed on the LCD. To deactivate DND: 1) Press the illuminated DND Flexible button again, or press the [DND ] Softkey while in an idle state to enable the DND feature. 2.14.
LIP-6812 User Guide 2.16. Shared Call Appearance / Bridge Line Appearance The LIP-6812 can support up to 11 Lines, each associated with its own button. A Line button could be set up as a Private Line, a Shared Line or DSS/BLF Call Coverage Line. A Private Line is used by only one phone. A Shared Line is shared by more than one phone. To learn more about this, please refer to the VoIP Configuration section within the Installer Guide. A Shared Line appears and is accessible by an authorized set of Phones.
LIP-6812 User Guide Direct Station Selection (DSS) — one-touch calling to covered extensions, and the ability to pick up calls ringing at those extensions. Busy Lamp Field (BLF) — visual status indication of covered extensions. The DSS/BLF feature in the LIP-6812 uses the Shared call appearance feature. Operation of the DSS/BLF Coverage button however is distinctively different than a Shared Line. To call an idle covered extension: 1) Lift the handset, press , press , or press your Line button.
LIP-6812 User Guide 3. Advanced Services and the LIP-6812 LCD Menu This section describes how to view and use the Advanced Services available through the LCD menu. The Main Menu components and order of display may be different on your phone based on the service subscription. All features may not be available to you based on the service subscription. The LIP-6812 is equipped with Softkeys and two direction buttons, used to navigate and select items from menus.
LIP-6812 User Guide 3.2. Phone Book The LIP-6812 contains an internal Phone Book that has 100 entries. You can add to, delete, edit, and dial entries from the Phone Book. The Phone Book is accessed with a programmable button assigned for the Phone Book function (refer to Installer Guide for the steps to configure the Phone Book). To access the Phone Book menu: 1) Press the Phone Book button. 2) The Phone Book will display the first entry. Phone Book (Page 1) >1.
LIP-6812 User Guide 1) Press the Phone Book button. 2) Select the desired record; press the ¼ to view additional records. Phone Book (Page 1) >[01]Tom,1234 [Edit] [Add ] [Del ] ¼ 3) Select [Edit] Softkey. Phone Book (Page 1) >[15]Tommy,9876 [Edit] [Add ] [Del ] ¼ 4) Edit the Name, Number and Speed Number for the record, selecting the [ OK ] Softkey for each entry (use the [Mode] Softkey to enter characters).
LIP-6812 User Guide 3) Select [DAll] Softkey and [Yes ]. Phone Book (Page 1) >[15]Tommy,9876 [DALL] [Find] ¼ To search the records in the Phone Book: 1) Press the Phone Book button. 2) Press the ¼ to locate the [Find] selection. Phone Book (Page 1) >[01]Tom,1234 [DALL] [Find] ¼ 3) Select the [Find] Softkey and [Yes ]. Search for: [1] Tom [ » ] [Mode] [ OK ] ¼ 4) Enter the search criteria and select [ OK ] to view the search results. Phone Book (Page 1) >(15)Tommy,9876 [Edit] [Add ] [Del ] ¼ 3.3.
LIP-6812 User Guide 3.4. Group Call Pick Up Call pick up by group is a business phone feature that lets the user pick up a call ringing at an extension in the user’s call group. User call groups are defined in the Call Server. Note you may need to use dial codes if the [GPic] Softkey is not displayed. To pickup a call ringing at a group extension: 1) Press the ¼ to locate the [GPic] Softkey. 2) Press [GPic] Softkey. 3.5. Private Hold Your Call Server may provide “private hold”.
LIP-6812 LGN6812SB-1219-01.
