Internet Unit Installation Guide

46 Chapter 4 DIP switch settings
300867-G
Resetting your Instant Internet unit
Before you reset your Instant Internet unit, be sure to back up the configuration.
If you back up the configuration, you can easily restore it. For details, refer to
Using the BayStack Instant Internet Management Software Version 7.11.
To reset your Instant Internet unit:
1 Turn off your unit.
2 Record the current switch settings of your Instant Internet unit.
3 Set the switches to the configuration you want.
Refer to Switch settings for special configurations on page 44.
4 Turn on your unit.
The LEDs on the front of your unit flash and then glow steadily amber,
including the Power LED, when they completely match the sequence for the
selected switch settings.
5 Turn off your unit.
6 Reset the switches using the information recorded in step 2.
Refer to Table 4 through Table 10 beginning on page 42.
7 Turn on your unit.
Note: If you used the switch settings in Table 13 to disable the reset
password and configuration switch settings, the Power LED glows amber
and LEDs 18 flash red in the sequence of the selected switch settings.