User's Manual

38 Configuration

Nortel Networks Confidential

— Svc Pkg Enforcement Service

— SipFwdAdapter

— Transport Management

• “Additional SIP TCF Base tab configuration information” on page 90

• “OAM&P strategy” on page 92

Overview

Nortel Networks performs the initial installation and commissioning.

Once the installation and commissioning are completed, you can begin

to make your system fully operational. The following list identifies some

general tasks:

• provision and complete translations to enable voice and trunk

services

• configure any additional services, applications, and features that

Nortel Networks is not contracted to perform

• complete the installation of clients or add client software for all

management interfaces

The SIP Application Module is configured using the System

Management Console. For more information, refer to the MCP

Management Module Basics and the MCP System Management

Console Basics documents. This chapter describes the configurable

parameters affecting operation of the SIP Application Module and the

procedures for configuration required at the service provider premises.

Deployment from the System Management Console results in the

installation of all SIP Application Module-specific software and

configuration data on the host machine, and starts the software

processes. Undeployment stops the software processes and removes

all related software and configuration data. When the deployment is

complete, the SIP Application Module should be unlocked, enabled,

and available to provide service.

Before a SIP Application Module can be deployed, the server must

have been configured at the System Management Console. This server

CAUTION

Before making any changes to the base

configuration, consult your next level of support.