Computer Hardware Installation Guide

ManualsBrandsNortel Networks ManualsComputer HardwareCircuit Card 311

491

492

493

494

495

496

497

498

499

500

Conﬁguring the Data Access card 493

Printing the card parameters (LD 20)

By responding R232, R422, or DAC to the TYPE prompt in LD 20, you can

print out the conﬁgured parameters for each port, or the entire DAC. This is

useful to determine if any parameters have been altered during keyboard or

Hayes dialing modify procedures.

LD 20 - Print DAC parameters.

Prompt Response Description

REQ: PRT

LTN

LUU

Print data, TN, or unit information for the unit specified

TYPE: R232

R422

DAC

Print information for the RS-232-C, RS-422 ports, or the

whole DAC

TN l s c u Print information for this TN, where l = loop, s = shelf, c =

card, u = unit. Uploaded parameters can only be printed

when a specific TN is listed.

The operation parameter printout for an RS-232 or RS-422 port is similar

to the following, depending on the conﬁguration.

Table 194

Print out example

DBASE

R-232 or R-422

UPLOAD

R-232 or R-422

PAR SPAC SPAC

DTR ON ON

HOT OFF OFF

AUT ON O

AUTB ON ON

BAUD

9600 4800

DCD OFF OFF

PRM KBD ON KBD ON

DEM DCE DCE

DLNG FRN FRN

KBD ON ON

Note: The Upload parameters are printed only when a single TN is specified.

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311 01.04 Standard

Release 5.0 23 May 2008