Computer Hardware Installation Guide

Installation and configuration 221
equipment through the switch software, the T1 channel number must be
cross-referenced to the corresponding card unit number. This mapping is
shown in Table 102 "DX-30 to T1 time slot mapping" (page 221).
Table 102
DX-30 to T1 time slot mapping
TN
T1 Channel Number
Motherboard
01
Motherboard
12
Motherboard
23
Motherboard
34
Motherboard
4
5
Motherboard
5
6
Motherboard
6
7
Motherboard
7
8
Motherboard
89
Motherboard
910
Motherboard
10 11
Motherboard
11 12
Motherboard
12 13
Motherboard
13 14
Motherboard
14 15
Motherboard
15 16
Daughterboard
017
Daughterboard
118
Daughterboard
219
Daughterboard
320
Daughterboard
421
Daughterboard
5
22
Daughterboard
623
Daughterboard
7
24
Disconnect supervision
The Lineside T1 card supports far-end disconnect supervision by opening
the tip side toward the terminal equipment upon the system’s detecting a
disconnect signal from the far-end on an established call. The Supervised
Analog Line feature (SAL) must be configured in LD 10 for each Lineside T1
port. At the prompt FTR, respond:
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
Copyright © 2003-2008, Nortel Networks
.