Enterprise Edge M7310 Quick Reference Guide © 2000 Nortel Networks P0908513 Issue 03
Your Enterprise Edge M7310 Telephone Shift button For using the top function of a dual-memory button. Display shows the time, date, call information, and guides you. The lower line of the display is reserved for display button instructions. Dual-memory buttons store any two features and/or autodial numbers. Display buttons Feature button starts or ends a feature. Release button cancels active calls.
Making and answering calls Answering calls Answering calls using the handset When your telephone rings, or º flashes beside an Intercom or line button: 1. Lift the handset. OR Press the button beside the flashing º before lifting the handset. Answering calls using Handsfree When your telephone rings, or º flashes beside an Intercom or line button: 1. Press ©. Making calls Depending upon the dialing mode programmed on your telephone, you may have to lift the handset before making a call.
Making and answering calls continued © System Administrator can program Handsfree for your telephone. Switching between Handsfree and handset 1. Press © and replace the handset to switch to Handsfree. 2. Pick up the handset to switch back. Using Mute 1. Press ©microphone OFF. 2. Press © again to turn the microphone ON. Making calls using Handsfree Press © instead of lifting the handset.
Programming memory buttons About memory buttons Memory buttons store telephone numbers or feature codes to give you one-touch dialling or feature activation. To use the top function, press the shift button, then press the dual-memory button. There are two types of memory buttons: single-memory and dual-memory. Dual-memory buttons: To use the bottom function, press the dual-memory button. Single-memory buttons: Single-memory buttons are the buttons with indicators other than line or Handsfree buttons.
Setting up the telephone ATTENTION Before attempting to carry out any work on the telephone, ensure that the line cord is unplugged from the wall socket. To remove any of the cords, squeeze the release latch on the plug and gently pull the plug from the socket. Connecting the cords Connect to jack from distribution block Connect to receiver Connect the handset cord to the jack labelled with the telephone icon and route the cord as shown.
Setting up the telephone Mounting the telephone on the wall Page 6 Enterprise Edge M7310 Quick Reference Guide P0908513 Issue 03
