Installation Guide

BTR 28 GHz Release 1.2 1-19
BTR 28 GHz Installation Guide
Installing Indoor Equipment
Both the primary and the redundant BTR 28 GHzs are connected to and
switched by the RPE 9000. The RPE 9000 is connected to both the RSM 9016
and the RSM 9116. The RSM 9016 is connected to the SMMs, while the
RSM 9116 is connected to the SDMs. The RSM 9016, RSM 9116, SMMs
(Signal Modulator Module) and SDMs (Signal Demodulator Module) are
installed in the NNE (Network Node Equipment unit). The SMMs modulate
ATM cells for wireless transport, while the SDMs interface RF to digital at
the base station and demodulates the QAM signal.
Install the indoor equipment associated with the BTR 28 GHz microwave
transceiver as follows:
1. Connect the telemetry cable from the RPE 9000’s telemetry connector to
the RSM 9016.
2. Connect the TX/PS coaxial cable from the RPE 9000 to the RSM 9016.
3. Connect the RX coaxial cable from the RPE 9000 to the RSM 9116.
4. Refer to the Reunion Redundancy Switching Matrix Installation Guide,
411-1313-201.
5. Refer to site specific documentation for detailed information, such as the
supplied engineer’s documentation.
Figure 1-9
Block Diagram showing BTR 28 GHz indoor set-up
RPE 9000
A
BTR 28 GHz
B
RSM 9016 RSM 9116
SMMs SDMs
TelemetryTelemetry
TX/PS TX/PS
RXRX
Telemetr y
RXTX/PS
-48 DC
.......
......
BTR 28 GHz