Telephone System Installation and Maintenance Guide

Chapter 7 Installing the main unit 89
BCM50 Installation and Maintenance Guide
Installing the BCM50 unit on a desktop or shelf
To mount a BCM50 unit on a desktop or shelf, attach the supplied rubber feet to the bottom of the
unit. If the BCM50 system includes additional units, you can set the additional units beside, or
stack them on top of, the first unit. If you are mounting the additional units beside the first unit,
attach the supplied rubber feet to the bottom of each unit. If you are stacking the additional units
on top of the first unit, mount each unit into the tabs on top of another unit.
To install the BCM50 unit on a desktop or shelf
To install the BCM50 unit on a desktop or shelf:
1 Insert the power supply retention clip into the BCM50 unit.
2 Attach the four self-adhesive rubber feet to the bottom of the BCM50 unit by peeling off the
paper backing and placing the feet on the unit as indicated in Figure 38.
Figure 38 Location for feet on the bottom of the BCM50 unit
3 Position the BCM50 unit on a table or shelf. Make sure you leave enough space around the
unit for ventilation and access to the cables.
4 If the BCM50 system has additional units, you can install the other units on top of, or beside,
the existing BCM50 unit.
Caution: Refer to “Checking the installation prerequisites” on page 75 for acceptable
environmental conditions before selecting a location for the BCM50 system.
Note: To keep the BCM50 unit operating at the optimal internal temperature, keep the
top, sides, and rear clear of obstructions and away from the exhaust of other equipment.
Do not place any objects, except other BCM50 units, on top of the main unit.
Attach feet here