Telephone System Installation and Maintenance Guide

136 Chapter 14 Using Element Manager to set the basic parameters
N0027152 01N0027152 01
To configure the modem
1 From the Configuration tab, click the Administrator Access folder to expand it.
2 Select Modem from the Administrator Access folder.
3 Select or deselect the Enable modem checkbox, depending on your system requirements.
For more information on modem configuration, refer to the BCM50 Networking Configuration
Guide (N0027156).
To configure the start-up template for telephony services
1 From the Administration tab, click the Utilities folder to expand it.
2 Select Reset from the Utilities folder.
3 Click Cold Reset Telephony Services. The Cold Reset Telephony dialog box opens.
4 Configure the Cold Reset Telephony attributes (see Table 23).
5 Click Ok.
To initialize voice mail
1 From the Configuration tab, click Applications folder to expand it.
2 Select Voice Messaging/Call Center from the Applications folder.
3 Click Launch CallPilot Manager. The Quick Install Wizard form opens.
If your voice mail system is already initialized, you will not see the Quick Install Wizard.
Instead you will see the System Properties web page.
Note: This procedure erases all the telephony programming that is currently on
BCM50 the system.
Table 23 Cold Reset Telephony attributes
Attribute Description
Region Specify the startup region.
Template Specify the startup template.
Start DN Specify the startup DN. The default is 221.