Telephone System Installation and Maintenance Guide

112 Chapter 9 Connecting the cables to the BCM50 system
N0027152 01N0027152 01
6 Tighten the screws to hold the wires in place.
7 Re-install the terminal block on the patch panel.
8 Connect the wires (digital telephones, analog telephones, and analog trunks) to the patch
panel.
9 Connect cables to the main unit as required.
Next step
After you have connected the cables to the BCM50 system, you can configure the initial
parameters. Refer to “Installing telephones and peripherals” on page 113 for information about
configuring these parameters.