BayStack User Guide

Using the BayStack 350 10/100/1000 Series Switch
2-4
304376-B Rev 00
To install the switch on a tabletop, shelf, or any other flat surface, follow these
steps:
1.
Set the switch on the flat surface and check for proper ventilation.
Allow at least 2 inches (5.1 cm) on each side for proper ventilation and
5 inches (12.7 cm) at the back for power cord clearance.
2.
Attach rubber feet to each marked location on the bottom of the chassis.
The rubber feet are optional but recommended to keep the unit from slipping.
3.
Attach all devices to the ports.
See “Attaching Devices to the BayStack 350 Switch
” on page 2-8.
Precaución:
Cuando este dispositivo se instala apilado en un estante o sobre
una mesa, el peso acumulado de los cables de los puertos aumenta según la
altura del estante o de la mesa.
Attenzione:
Quando il dispositivo viene installato in stack su un ripiano o su
un tavolo, il peso dei cavi connessi alle porte aumenta in proporzione
all'altezza del ripiano o del tavolo.
kombk.book Page 4 Thursday, February 18, 1999 10:59 AM