BayStack User Guide

304376-B Rev 00
D-1
Appendix D
Connectors and Pin Assignments
This appendix describes the BayStack 350 switch port connectors and pin
assignments.
RJ-45 (10BASE-T/100BASE-TX) Port Connectors
The RJ-45 port connectors (Figure D-1) are wired as MDI-X ports to connect end
stations without using crossover cables. (See “
MDI and MDI-X Devices” on
page D-2
for information about MDI-X ports.) For 10BASE-T connections, use
Category 3 (or higher) UTP cable. For 100BASE-TX connections, use only
Category 5 UTP cable.
Figure D-1. RJ-45 (8-Pin Modular) Port Connector
18
616EA
kombk.book Page 1 Thursday, February 18, 1999 10:59 AM