BayStack User Guide

Installing the BayStack 350 Switch
304376-B Rev 00
2-11
3.
Connect the female connector of the RS-232 cable directly to the
Console/Comm Port on the switch, and tighten the captive retaining
screws (see Figure 2-6
).
Figure 2-6. Connecting to the Console/Comm Port
4.
Connect the other end of the cable to a terminal or the serial connector of
a personal computer running communications software.
5.
Proceed to the next section, “Connecting Power,” to connect the AC
power cord and power up the BayStack 350 switch.
Connecting Power
The BayStack 350 switch does not have a power on/off switch. When you connect
the AC power cord to a suitable AC power outlet, the switch powers up
immediately.
Warning:
Removal of the power cord is the only way to turn off power to this
device. The power cord must always be connected in a location that can be
accessed quickly and safely in case of an emergency.
Vorsicht:
Die Stromzufuhr zu diesem Gerät kann nur durch Ziehen des
Netzstromkabels unterbrochen werden. Die Netzsteckdose, an die das
Netzstromkabel angeschlossen ist, muß sich stets an einem Ort befinden, der
bei einem Notfall schnell und einfach zugänglich ist.
Comm Port
172FC
kombk.book Page 11 Thursday, February 18, 1999 10:59 AM