Network Adapter Installing and Operating Manual

Installing the AN/DC
312410-A Rev 00
1-19
3.
Strip 3/8 in. (10 mm) of insulation from the end of a #16 or #18 AWG
cable.
4.
Insert the stripped end of the cable into the -VDC terminal block, the
minus lead (Figure 1-12)
.
5.
Tighten the screw beneath the -VDC terminal block to establish the
electrical connection.
Figure 1-12. Attaching AN/DC Power Input Cables
6.
Strip 3/8 in. (10 mm) of insulation from a #16 or #18 AWG cable.
Make certain to use the same wire gauge as that used for the minus lead.
7.
Insert the stripped end of the cable into the RTN terminal block, the plus
lead (Figure 1-12)
.
8.
Tighten the screw beneath the RTN terminal block to establish the
electrical connection.
Note:
Although #18 AWG cable is adequate, we recommend #16 AWG cable
to ensure minimal voltage drop from the power source.
COM 1
U
L
U
L
AN0091B
RTN -VDC
-48VDC
-60VDC
1.5A
Power Switch OFF (0)