Network Adapter Installing and Operating Manual

Installing and Operating AN/DC and ANH-8/DC Systems
B-12
312410-A Rev 00
Using the Quick-Start Commands
Refer to the commands in Table B-1 when quick-starting the AN/DC or
ANH-8/DC.
SMDS Worksheet
Requested Information Options Your Information
Enter 10-digit individual
address:
Enter the individual address
assigned to you by your SMDS
service provider.
Enter 10-digit group address:
Enter the group address assigned
to you by your SMDS service
provider.
Enter 10-digit arp address:
Enter the Address Resolution
Protocol (ARP) address assigned
to you by your SMDS service
provider.
Table B-1. Quick-Start Commands
To Do the Following Action Details
Accept a default value Press
Return
Your console displays default values in
brackets; for example, [E11].
Repeat a step (for
example, if you make a mistake)
Press
Control-c
Press
n
When prompted
Terminate script y/n?
press the
n
key. You return to the beginning of
the step so that you can reenter the
information.
Stop the Quick-Start
installation procedure
Press
Control-c
Press
y
When prompted
Terminate script y/n?
press the
y
key. The Quick-Start procedure
terminates and you return to the Technician
Interface prompt.
To restart the Quick-Start procedure, you must
reboot the AN by typing
boot
and pressing the
Return key.