Switch User Manual

Alteon OS Command Reference
244
 The Configuration Menu BMD00007, November 2007
/cfg/l2/lacp/port <port alias or number>
LACP Port Configuration
Use the following commands to configure Link Aggregation Control Protocol (LACP) for the
selected port.
[LACP Port EXT1 Menu]
mode - Set LACP mode
prio - Set LACP port priority
adminkey - Set LACP port admin key
cur - Display current LACP port configuration
Table 6-48 LACP Port Menu Options (/cfg/l2/lacp/port)
Command Syntax and Usage
mode off|active|passive
Set the LACP mode for this port, as follows:
 off
Turn LACP off for this port. You can use this port to manually configure a static trunk. The
default value is off.
 active
Turn LACP on and set this port to active. Active ports initiate LACPDUs.
 passive
Turn LACP on and set this port to passive. Passive ports do not initiate LACPDUs, but respond
to LACPDUs from active ports.
prio <1-65535>
Sets the priority value for the selected port. Lower numbers provide higher priority. Default is
32768.
adminkey <1-65535>
Set the admin key for this port. Only ports with the same admin key and oper key (operational state
generated internally) can form a LACP trunk group.
cur
Displays the current LACP configuration for this port.