Passport Module User Guide

136 Chapter 6 Configuring the Passport 8672ATME Module
209195-B
5 Click Enable.
6 Click Apply.
The OSPF tab closes, and the IP Address tab is redisplayed.
7 Click Close.
Configuring a null-encapsulation PVC
See “Configuring two ATM 1483 PVCs on the same ATM port” on page 128.
Associating the PVC with the VLAN
See “Associating the PVC with the VLAN” on page 126.
Follow the instructions there except, in the ConnectType field, select IP instead of
bridged.
Configuring an IP routing 1483 PVC using the CLI
To configure the Passport 8672ATME Module for an ATM 1483 IP routed PVC,
using the CLI:
1 To create two VLANs by port, enter:
config vlan 2 create byport 1
config vlan 3 create byport 1
AreaId A 32-bit integer uniquely identifying the area to which the
interface connects. Area ID 0.0.0.0 is used for the OSPF
backbone.
AdvertiseWhenDown Value used indicates whether or not a VLAN state change
should be notified to layer 3, provided that the VLAN is
configured as a routable interface. Also used for single routable
ports. In that case, the criteria for state is PortOperStatus.
Table 48 OSPF tab fields (continued)
Field Description