Passport Module User Guide

Chapter 5 Managing the Passport 8672ATME Module with the CLI 115
Using the Passport 8672ATME Module
Table 40 defines the status and statistics in the show ports info atm f5-oam
[slot/port]
command.
clear atm f5-oam [slot/port]
This command clears the F5-OAM statistics for all the F5-OAM loopbacks that
are currently enabled under the ATM port and slot.
To clear all the F5-OAM statistics for a particular ATM port and slot, enter this
command:
Passport-8610:5#
clear atm f5-oam 2/3
Table 40 Status and statistic definition
F5 VC Status Definition
NOT MANAGED The VC is not being managed by OAM. (The VC is not
transmitting F5-OAM Loopback Requests as F5-OAM Loopback
is disabled.)
DOWN VERIFY An OAM loopback failed. End-to-end F5-OAM loopback cells are
sent at the specified retry frequency to verify that the VC is
down. After down-count unsuccessful retries, the VC goes to the
down state (see LbDownCount in Table 13 on page 71).
DOWN The VC has not received responses to end-to-end F5-OAM
loopback cells.
UP VERIFY An OAM loopback was successful. End-to-end F5-OAM
loopback cells are sent at the specified retry frequency to verify
the VC is really up. After up-count successive and successful
loopback retries, the VC goes to the Up state (see LbUpCount in
Table 13 on page 71).
UP End-to-end loopbacks are successful.
Loopback Req Sent Number of F5-OAM Loopback requests transmitted for a
particular PVC.
Loopback Reply Rcv Number of F5-OAM Loopback replies received for a particular
PVC.
Loopback Reply Sent Number of F5-OAM Loopback replies transmitted in response to
a F5-OAM Loopback Request Received for a particular PVC.
Although this functionality occurs while the F5-OAM Loopback is
disabled, this statistic only starts when the F5-OAM Loopback is
enabled.